Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
(a) Replace the sliding roof drive gear assembly See: Body and Frame/Roof and Associated Components/Sunroof / Moonroof/Service
and Repair/Removal and Replacement/Removal.
NEXT -- Continue to next step.
5. CHECK DTC OUTPUT
(a) Clear the DTC See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes.
(b) Recheck for DTCs.
OK:
DTC B1273 is not output.
NG -- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) See: Body and Frame/Body Control
Systems/Body Control Module/Service and Repair/Removal
OK -- END (SLIDING ROOF DRIVE GEAR ASSEMBLY WAS DEFECTIVE)
No comments:
Post a Comment