NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference
values when deciding whether a part is faulty or not.
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Powertrain / ECT / Data List.
(f) According to the display on the Techstream, read the Data List.
Standard:
NOTICE:
In the table above, the conditions listed under "Normal Condition" are reference conditions. Do not depend solely on these
reference conditions when deciding whether a part is faulty.
Result:
B -- CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - TCM)
A -- Continue to next step.
2. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Remove the stop light switch assembly.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE STOP LIGHT SWITCH ASSEMBLY
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - TCM)
(a) Install the stop light switch assembly.
No comments:
Post a Comment