SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: B1850/62-B1853/62: Short in Rear Side Squib RH Circuit
B1853/62 - Short to B+ in Rear Side Squib RH Circuit
DESCRIPTION
The rear side squib RH circuit consists of the center airbag sensor assembly and rear seat side airbag assembly RH.
This circuit instructs the SRS to deploy when deployment conditions are met.
These DTCs are stored when a malfunction is detected in the rear side squib RH circuit.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT
* Perform the simulation method by selecting the Check Mode (Signal Check) using the Techstream See: Restraints and Safety
Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Check Mode Procedure.
* After selecting the Check Mode (Signal Check), perform the simulation method by wiggling each connector of the airbag
system or driving the vehicle on a city or rough road See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting.
PROCEDURE
1. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
No comments:
Post a Comment