2. REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)
(a) Remove optional components (including associated wiring).
NOTICE:
Do not remove optional components or associated wiring without the permission of the customer.
NEXT -- Continue to next step.
3. CHECK DTC
(a) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for HDD).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY POWER SOURCE)
OK -- END
1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY POWER SOURCE)
(a) Disconnect the G16 multi-display controller sub-assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR
(a) Disconnect the G16 multi-display controller sub-assembly connector.
No comments:
Post a Comment