OK:
DTC B1865, B1866, B1867, B1868, or 65 is not output.
Text in Illustration
HINT
Codes other than DTC B1865, B1866, B1867, B1868, and 65 may be output at this time, but they are not related to this check.
NG -- CHECK INSTRUMENT PANEL WIRE (FRONT PASSENGER SIDE KNEE AIRBAG SQUIB CIRCUIT)
OK -- REPLACE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY See: Restraints and Safety Systems/Air Bag
Systems/Air Bag/Service and Repair/Removal and Replacement/Knee Airbag Assembly (for Front Passenger Side)/Removal
3. CHECK INSTRUMENT PANEL WIRE (FRONT PASSENGER SIDE KNEE AIRBAG SQUIB CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect SST from connector C.
(d) Disconnect the instrument panel wire from the center airbag sensor assembly.
(e) Check for a short to B+ in the circuit.
(1) Connect the cable to the negative (-) battery terminal.
(2) Turn the engine switch on (IG).
(3) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(f) Check for an open in the circuit.
(1) Turn the engine switch off.
(2) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(3) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment