DESCRIPTION
* The driver side squib circuit consists of the center airbag sensor assembly, spiral cable and steering pad.
* The circuit instructs SRS to deploy when deployment conditions are met.
* These DTCs are recorded when a malfunction is detected in the driver side squib circuit.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT
* Perform the simulation method by selecting the check mode (Signal Check) using the Techstream See: Restraints and Safety
Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Check Mode Procedure.
* After selecting the check mode (Signal Check), perform the simulation method by wiggling each connector of the airbag
system or driving the vehicle on a city or rough road See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting.
PROCEDURE
1. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
No comments:
Post a Comment