(b) Disconnect the R4 rear height control sensor sub-assembly RH connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
6. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
(a) Connect 3 dry cell batteries (1.5 V) in series.
(b) Remove the rear height control sensor sub-assembly RH See: Lighting and Horns/Headlamp/Headlamp Alignment Sensor/Service
and Repair/Components.
(c) Connect a positive (+) lead from the battery to terminal 3 (SHB) and a negative (-) lead from the battery to terminal 1 (SHG).
(d) Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.
No comments:
Post a Comment