Standard Resistance:
(g) Check for a short to ground in the circuit.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(h) Check for a short in the circuit.
(1) Release the activation prevention mechanism built into connector B See: Restraints and Safety Systems/Air Bag Systems/Testing
and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
(2) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE NO. 2 FLOOR WIRE
OK -- Continue to next step.
2. CHECK CENTER AIRBAG SENSOR ASSEMBLY
(a) Restore the released activation prevention mechanism of connector B to the original condition.
(b) Connect the connectors to the rear seat outer belt assembly LH and center airbag sensor assembly.
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
No comments:
Post a Comment