No DTCs are output.
NG -- CHECK HARNESS AND CONNECTOR (COMBINATION METER MIRROR ECU POWER SOURCE)
OK -- END
1. CHECK HARNESS AND CONNECTOR (COMBINATION METER MIRROR ECU POWER SOURCE)
(a) Disconnect the H1 combination meter mirror ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR
(a) Disconnect the H1 combination meter mirror ECU connector.
(b) Disconnect the G5 display and navigation module display connector.
(c) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment