(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connectors are properly connected to the side airbag sensor LH (for rear side), rear airbag sensor LH and side airbag
sensor LH (for front side). Also check that the connectors that link the No. 2 floor wire and front door wire LH are properly connected.
OK:
The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
(d) Disconnect the connectors from the side airbag sensor LH (for rear side), rear airbag sensor LH and side airbag sensor LH (for front
side). Also disconnect the connectors that link the No. 2 floor wire and front door wire LH.
(e) Check that the terminals of connectors are not damaged.
OK:
The terminals are not deformed or damaged.
NG -- REPLACE WIRE HARNESS
OK -- Continue to next step.
33. CHECK NO. 2 FLOOR WIRE (OPEN)
(a) Using SST, connect terminals 4 (BCL+) and 3 (BCL-) of connector C.
NOTICE:
Do not forcibly insert SST into the terminals of the connector when connecting.
SST : 09843-18040
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE NO. 2 FLOOR WIRE
OK -- Continue to next step.
34. CHECK NO. 2 FLOOR WIRE (SHORT)
(a) Disconnect SST from connector C.
No comments:
Post a Comment