WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* If the certification ECU (smart key ECU assembly) is replaced, register the key.
* If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID.
* When using the Techstream to troubleshoot with the engine switch off:
* Connect the Techstream to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication
between the Techstream and vehicle begins.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY AND BODY GROUND)
(a) Disconnect the F45 connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
Standard Resistance:
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)
(a) Disconnect the F58 connector.
No comments:
Post a Comment