(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY See: Body and Frame/Seats/Power Seat
Switch/Service and Repair/Power Seat Switch/Removal
OK -- REPLACE FRONT SEAT ASSEMBLY LH See: Body and Frame/Seats/Testing and Inspection/Component Tests and
General Diagnostics/Front Seat Assembly
From 08/2009
SEAT: FRONT POWER SEAT CONTROL SYSTEM (w/ Memory): B2658: Short in Sensor with Motor Power Supply Circuit
B2658 - Short in Sensor with Motor Power Supply Circuit
DESCRIPTION
This DTC is stored if sensor voltage does not reach the designated voltage while the slide motor is operating.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / D- Seat / Trouble Codes.
(e) Clear the DTC See: Body and Frame/Seats/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
(f) Recheck for DTC B2658.
No comments:
Post a Comment