1. READ VALUE USING TECHSTREAM (FUEL INPUT)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Data List.
(e) Check the values by referring to the table below.
Combination Meter
Result:
B -- INSPECT COMBINATION METER ASSEMBLY
A -- REPLACE COMBINATION METER ASSEMBLY See: Instrument Panel, Gauges and Warning Indicators/Instrument
Cluster / Carrier/Service and Repair/Removal and Replacement/Combination Meter/Removal
2. INSPECT COMBINATION METER ASSEMBLY
(a) Disconnect the F16 connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE
ASSEMBLY)
OK -- REPLACE COMBINATION METER ASSEMBLY See: Instrument Panel, Gauges and Warning Indicators/Instrument
Cluster / Carrier/Service and Repair/Removal and Replacement/Combination Meter/Removal
3. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE ASSEMBLY)
(a) Disconnect the P11 connector.
No comments:
Post a Comment