(b) Connect SST (resistance 2.1 Ohms) to connector C.
CAUTION:
Never connect the tester to the rear seat outer belt assembly LH (rear pretensioner squib LH) for measurement, as this may lead
to a serious injury due to airbag deployment.
NOTICE:
* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1925, B1926, B1927, B1928, or 78 is not output.
Text in Illustration
HINT
Codes other than DTC B1925, B1926, B1927, B1928, and 78 may be output at this time, but they are not related to this check.
NG -- CHECK NO. 2 FLOOR WIRE (REAR PRETENSIONER SQUIB LH CIRCUIT)
OK -- REPLACE REAR SEAT OUTER BELT ASSEMBLY LH See: Restraints and Safety Systems/Seat Belt Systems/Seat
Belt/Service and Repair/Removal and Replacement/Rear Seat Outer Belt Assembly/Removal
1. CHECK NO. 2 FLOOR WIRE (REAR PRETENSIONER SQUIB LH CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
No comments:
Post a Comment