(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the instrument panel wire connector from the engine room main wire.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the engine switch on (IG).
(f) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPLACE INSTRUMENT PANEL WIRE
OK -- REPLACE ENGINE ROOM MAIN WIRE
10. CHECK INSTRUMENT PANEL WIRE (SHORT TO GROUND)
(a) Disconnect the instrument panel wire connector from the engine room main wire.
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment