NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU POWER SOURCE)
(a) Reconnect the display and navigation module display connector.
(b) Disconnect the multi-media interface ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY
OK -- Continue to next step.
6. REPLACE MULTI-MEDIA INTERFACE ECU
(a) Replace the multi-media interface ECU See: Accessories and Optional Equipment/Entertainment Systems/Entertainment System
Control Module/Service and Repair/Multi-Media Interface ECU/Removal.
(b) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for DVD).
(c) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY
No comments:
Post a Comment