RR-Door Motor (Power Window Regulator Motor Assembly (for Rear RH Side))
INSPECTION PROCEDURE
NOTICE:
* When the power window regulator motor assembly is reinstalled or replaced, the power window control system must be
initialized.
* After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto
up function is used. In such cases, the auto up function can be reinitialized by repeating the following operations at least 5
times:
* Close the power window by fully pulling up the multiplex network master switch or power window regulator switch
assembly and holding it at the auto up position.
* Open the power window by fully pushing down the switch.
PROCEDURE
1. PERFORM INITIALIZATION (APPLICABLE LOCATION)
(a) Turn the engine switch on (IG).
(b) Initialize the power window regulator motor assembly See: Windows and Glass/Windows/Testing and Inspection/Programming and
Relearning/Initialization.
HINT
Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.
NEXT -- Continue to next step.
2. CHECK DTC OUTPUT
(a) Turn the engine switch off.
(b) Wait for at least 10 seconds, and then turn the engine switch on (IG).
(c) Check for DTCs See: Windows and Glass/Windows/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
HINT
Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.
OK:
DTC B2313 is not output.
No comments:
Post a Comment