Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - POWER MANAGEMENT CONTROL ECU)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND)
(a) Disconnect the F8 connector from the power management control ECU.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY
GROUND)
OK -- Continue to next step.
3. INSPECT IG1 RELAY
(a) Remove the IG1 relay from the engine room relay block assembly.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE IG1 RELAY
OK -- Continue to next step.
No comments:
Post a Comment