forward and backward. The telescopic position sensor (Hall IC) in the telescopic motor detects the sliding position in the forward and backward
directions of the steering column and outputs a signal to the multiplex tilt and telescopic ECU based on that sliding amount.
HINT
Limit positions can be confirmed on the Techstream.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspection the fuses for circuits related to this system before performing the following inspection procedure.
HINT
The wire harness between the multiplex tilt and telescopic ECU and telescopic motor is provided with the steering column
assembly.
PROCEDURE
1. PERFORM ACTIVE TEST USING TECHSTREAM (TELESCO OPERATION)
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
No comments:
Post a Comment