(b) Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
(c) Measure the resistance according to the value(s) in the table below.
HINT
This inspection is to check the LIN line in the instrument panel junction block assembly that connects the wire harness to the
built-in main body ECU (multiplex network body ECU).
Standard Resistance:
Text in Illustration
NG -- REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR
(a) Disconnect the L2 connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
No comments:
Post a Comment