OK:
DTC B1925, B1926, B1927, B1928, or 78 is not output.
Text in Illustration
HINT
Codes other than DTC B1925, B1926, B1927, B1928, and 78 may be output at this time, but they are not related to this check.
NG -- CHECK NO. 2 FLOOR WIRE (REAR PRETENSIONER SQUIB LH CIRCUIT)
OK -- REPLACE REAR SEAT OUTER BELT ASSEMBLY LH See: Restraints and Safety Systems/Seat Belt Systems/Seat
Belt/Service and Repair/Removal and Replacement/Rear Seat Outer Belt Assembly/Removal
1. CHECK NO. 2 FLOOR WIRE (REAR PRETENSIONER SQUIB LH CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect SST from connector C.
(d) Disconnect the No. 2 floor wire from the center airbag sensor assembly.
(e) Check for a short to B+ in the circuit.
(1) Connect the cable to the negative (-) battery terminal.
(2) Turn the engine switch on (IG).
(3) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(f) Check for an open in the circuit.
(1) Turn the engine switch off.
(2) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(3) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment