(b) Remove the AIR SUS relay from the engine room J/B.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPLACE AIR SUS RELAY
OK -- Continue to next step.
2. INSPECT HEIGHT CONTROL COMPRESSOR ASSEMBLY (COMPRESSOR MOTOR)
(a) Disconnect the compressor motor connector.
(b) Connect a positive (+) lead from the battery to terminal 1 (B) and a negative (-) lead to terminal 2 (E).
(c) Check the operation of the compressor motor.
OK:
Motor operates
Text in Illustration
NOTICE:
- Do not operate the height control compressor for 60 seconds or more.
- Stop applying voltage immediately if the compressor stops operating because a short will occur and the compressor motor will
lock up, causing the flow of excessive current.
NG -- REPLACE HEIGHT CONTROL COMPRESSOR ASSEMBLY See: Steering and Suspension/Suspension/Suspension
Control ( Automatic - Electronic )/Compressor/Pump/Service and Repair/Removal
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (POWER SOURCE OF COMPRESSOR MOTOR)
(a) Remove the AIR SUS relay from the engine room J/B.
No comments:
Post a Comment