NOTICE:
Perform the universal trip to clear permanent DTCs See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/U660F Automatic Transaxle
System/DTC Check / Clear.
HINT
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read
without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be
discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save
diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference
values when deciding whether a part is faulty or not.
- Warm up the engine.
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / ECT / Data List.
- According to the display on the Techstream, read the Data List.
TCM
HINT
When DTC P0712 is output and the Techstream indicates 150锟斤拷C (302锟斤拷F) or more, there is a short circuit.
When DTC P0713 is output and the Techstream indicates -40锟斤拷C (-40锟斤拷F), there is an open circuit.
Measure the resistance between terminal THO1 (OT) and body ground.
HINT
If the circuit related to the ATF temperature sensor becomes open, P0713 is immediately set (in 0.5 seconds). When P0713 is set,
P0711 cannot be detected.
It is not necessary to inspect the circuit when P0711 is set.
PROCEDURE
1. INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
(a) Remove the TCM from the transaxle.
No comments:
Post a Comment