Codes other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.
C -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraints and Safety
Systems/Air Bag Control Module/Service and Repair/Removal
B -- REPLACE REAR AIRBAG SENSOR RH
A -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
From 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: B1630/23: Rear Airbag Sensor RH Circuit Malfunction
B1630/23 - Rear Airbag Sensor RH Circuit Malfunction
DESCRIPTION
The side collision sensor RH circuit (to determine deployment of the front seat side airbag assembly RH, rear seat side airbag assembly RH and
curtain shield airbag assembly RH) is composed of the center airbag sensor assembly, side airbag sensor RH (for rear side), rear airbag sensor RH
and side airbag sensor RH (for front side).
The rear airbag sensor RH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be
deployed.
DTC B1630/23 is recorded when a malfunction is detected in the rear airbag sensor RH.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK REAR AIRBAG SENSOR RH
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
No comments:
Post a Comment