(m)Measure the line pressure with SST.
(n) *: "Activate the Solenoid (SLT)" in the Active Test is performed to check that the line pressure changes by connecting the SST to the
automatic transaxle. The same SST is used in the Hydraulic Test See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/U660F Automatic Transaxle
System/Hydraulic Test as well.
HINT
The pressure values in Active Test and Hydraulic Test are different from each other.
OK:
The line pressure changes as specified when performing the Active Test.
NG -- INSPECT SHIFT SOLENOID VALVE SLT
OK -- Continue to next step.
3. PERFORM ACTIVE TEST USING TECHSTREAM (SHIFTING TEST)
NOTICE:
This test should always be performed with at least 2 people.
(a) Warm up the engine.
(b) Turn the engine switch off.
(c) Connect the Techstream to the DLC3.
(d) Turn the engine switch on (IG).
(e) Turn the Techstream on.
(f) Enter the following menus: Powertrain / ECT / Active Test.
(g) According to the display on the Techstream, perform the Active Test.
HINT
Comparing the gear commanded by the Active Test with the actual gear enables confirmation of the problem See: Transmission
and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Initial Inspection and Diagnostic Overview/U660F
Automatic Transaxle System/Fail-Safe Chart.
NOTICE:
- This test can be conducted when the vehicle is stopped.
- When shifting gears using the Active Test function, do not operate the accelerator pedal for 2 seconds before and after shifting
No comments:
Post a Comment